Now we'll change a few settings to personalize your Pi.ĭealing with a Black Screen If you boot up your Pi but nothing is displayed on your monitor, it's probably not a hardware problem. When you boot up your Pi, it will bring you to a login prompt. Use the serial console or SSH to the IP address given to the board by your router. Insert the SD card into the Raspberry Pi, connect ethernet, and apply 5V power. Wget (ARMv8 圆4 version for v3 ONLY, not fully supported)īsdtar -xpf -C root Wget (this is the ARMv6 verison for RPi1 and 0) Write the partition table and exit by typing w.ĭownload and extract the root filesystem (as root, not via sudo): Type n, then p for primary, 2 for the second partition on the drive, and then pressĮNTER twice to accept the default first and last sector. Type t, then c to set the first partition to type W95 FAT32 (LBA). Type n, then p for primary, 1 for the first partition on the drive, press ENTER toĪccept the default first sector, then type +100M for the last sector. This will clear out any partitions on the drive. Any guides or information that reference these scripts, or a file called /etc/rc.conf is now depreciated and will probably break your system.Ī minimal guide for experienced Linux users to set up the SD-card is as follows:Īt the fdisk prompt, delete old partitions and create a new one: Arch has now finished it's transition to SystemD from the old initscripts. On a cautionary note, Arch moves forward as technology evolves, and this can sometimes lead to documentation lagging behind. This minimizes the amount of SD card memory it takes to hold the operating system for your Raspberry Pi, leaving more space for everything else you'll be doing.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |